![]()
#Hp product lookup by serial number serial number#S/N : ( for your security, I have removed the serial number from your post above - that's information you probably don't want to make publicly available. | 08 | 09 | 10 | 11 | 12 | 13 | 14 | 15 |Ī - Active (configured and processes running)į - Inactive with fail (inactive because of a CPU failure)Ĭ - Marked for re-configuration (Configured after next boot)ĭ - Marked for de-configuration (De-configured after next boot) There are no "propplus" under my 11.31 machine, so, it is installed package?Ģ) does it mean "machinfo" command is impossible to get the CPU serial number? because it always return 0x0000ģ)I run "cstm>sel dev all wait il" on HPUX11.23 hppa Torsten and Bill, thank you all, I am so appricaited for your help.ĭuring my testing, I found the following problem: # /opt/propplus/bin/cprop -detail -c "Processors"īy the way Bill, your system is running old firmware. On a system running 11.31 try this to get the processor serial numbers: Secondary Product Name : Integrity rx2800 i2 Product Name (prodname) : Integrity rx2800 i2 Such board must be "factory new" with special values set, a "used" board will not work that way.įor BL8x0i2 and rx2800i2 servers the "sysset" command has been moved to the MP: It is stored in 2 locations, so if you replace the system board with a "fresh" one, it will be cloned to the new board. The machine serial number is something different. The processor serial number is all "0" - always. Processor model: 0 Intel(R) Itanium 2 processor Processor family: 31 Intel(R) Itanium 2 Family Processors ![]() This is a reasonable requirement as a lot of priced software requires a unique serial number fror licensing. #Hp product lookup by serial number serial numbers#HP sends out replacement boards without serial numbers and only HP service can set the serial numbers. ![]() It would appear that this machine was repaired and the system board was replaced. ![]() Vmunix $Revision: vmunix: B.11.31_LR FLAVOR=perf Intel(R) Itanseries processor (1.67 GHz, 18 MB) The normal output from machinfo looks like this:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |